The workflow of the density board production line
Release time:
Nov 14,2024
The entire process is manually set and fully automated for data processing.
The density board production line is divided into six processes: raw material cutting: sent to the conveyor chain, enters the cutting machine to cut into pieces, passes through the scraper and screening machine, enters the conveyor belt, and is sent to the silo. The entire process is manually set and fully automated for data processing. The density board production line needs to replace the lubricating oil with a lower viscosity oil in winter to facilitate smooth oil flow and provide good lubrication. When using the equipment in winter, the density board production line should be run at low speed for a few minutes to fully lubricate all parts before starting to use. Check and preheat the machine before daily work. The start-up of the density board production line should be carried out after the mechanical equipment has thawed to avoid unnecessary losses caused by freezing of the mechanical equipment.
Key words:
Next
Blog
Share